Recent content by Brax1942

Would a line driver with line outputs into my amps be ok? I would either do that, and use dsp amps or use a separate dsp processor from the line driver into my regular amps. My system will have a pair of 3 way components up front and two subs in the rear.

With regards to using an iPad mini as a head unit to play high res audio and other music what exactly is needed to make this work? Is a sound processor necessary?

Per information discovered in that particular face book group I will likely be starting out in my Ford Excursion by removing the headliner to glue 3/4” MDF or Plywood to the roof with each panel getting full coverage with a construction adhesive. Then I will reinstall the headliner. That is my...

So I am building an iPad mini based system that will play straight from my iPad to my amps. I have been told that I need at least an 8 channel amp (for a pair of 3 way components and 2 subs) and that the amp needs to have Bluetooth and preferably dsp. With that said, can you guys suggest an 8...

Ok so I am at the point in my build where I need to start picking out my subs. I will be using a round enclosure the size of a 35” x 16” tire. My vehicle is a Ford Excursion. Subs will be two 15”. Amps are going to be two 1,000 watt class D amps with dsp and Bluetooth. Budget will be $250 to...

I am looking at some 3 way component sets for the front of my Ford suv. I don’t listen loud, but I like clean, clear, detailed and accurate speakers. I play a lot of high res audio in my home system and want to do the same in my vehicle. With that said, is there anything better for the same cost...

What if I wanted to play high res audio or Flac or Wav?

Would I not need some sort of pre amp or processor to get the signal to the amps? If I used a Dayton dsp unit would it attach to the iPad mini via lightening or usb cable then go from that to the amps?

I need some way to get the audio out of my iPad mini to play through my system. That plus the ability to do active 3 way xovers and a single or duel subs. My source will be high res from the iPad

Looking into using a sound processor with an iPad mini head unit. What would be a good sound processor that is capable of running a pair of 3 way component speakers with a sub, and play high res audio? Not trying to spend $1500 on a sound processor, but I want something capable of the best audio...

I have been searching with not very good results. I wonder if there are any 32 bit 192khz with high res capability? If I can’t find a deal on a nice used one or find a new one for under a grand I will just bite the bullet and order a new Sony with those capability’s. The Sony is over $1,500.

So is mass loaded vinyl and closed cell foam still the best option over the Killmat?

I am curious what the cheapest double din head unit is that plays high res audio with the absolute highest bit rate and the best Dac chip?

So I am finally starting my build in my large Ford suv and I want to do sound deadening and sound proofing using weighted stick on deadened mat like Dynamat and then I also plan to use 2lb mass loaded vinyl with closed cell foam in between the mass loaded vinyl and the Dynamat style sound...

So I am doing a small but nice build in my older Ford suv and I need a head unit suggestion that would fit my needs. Here are my specific needs: 1.) ability to play flac, wav or lossless high res music 2.) preferably the highest playback resolution and bit rate. 192khz etc.. 3.) ability to run...