Recent content by chadwilliam1

Thanks, working on learning how to use the audio frog RTA and get this thing tuned correctly. i want to do something to hold the power wires for the map and keep them spaced evenly just cant decide on a good design I also need to make a cover for the sub box.

I hired a local shop to build my a pillars. I am happy with the results. I also finished hooking everything up and running the wires.

been busy, I redid the amp rack for a couple of reasons. 1, there wasnt enough room between the two amps so the support of the kenwood could hit the wolfram also i wanted to wrap it in vinyl. Here it is i have some wire clean up left to do.

I added battey tender hook ups to my trunk. I had to do two because i have an idolater. I decided this was the easiest route instead of activating the isolator. That little fuse box by the idolater is for the battery tender. I also upgraded my front battery ground, i just didnt like the looks...

Nice Work

oh and yes the amp you picked out will work it will just be enough . No room to grow.

I dont like to buy perfect matches sub and amp. I like my amps to have room so if i decide to upgrade the sub i dont need to replace the amp as well. You are looking for a mono amp. I like this one for your needs. I have two of them and they will last you a long time...

Set the gain on the bass amp and put the plexiglass window in. I don't like how the amp rack turned out. I will proably remake and use vinyl to wrap it. 

I decided to follow the advice of some people on this forum and deleted the rear deck speakers. Right now i am still wiring things up. I forgot to take a picture of the amp rack. i will do that tomorrow.

Got the box in, didn’t go quite as planned. The box fits but since the sub is designed to go in the top, I had to slide the box in through the trunk then i had to remove the rear seat and slide the box into the cab. I then installed the sub with the box part way in the cab then slid it back and...

Upgraded my fuse block. One goes to the cars electrical system, the 1/0 goes to my bass amp and a I added a third run for my dsp/6 channel amp while I was st it. Figured it was easier to run it now than later. Took me a while to figure out where to put it but I am happy with the end result. 

I have asked this question before and the best answer i got was as long as you can stay above 12v you are doing ok.

Rode up to parts express on the motorcycle to pick up some more charcoal carpet.

here is the amp rack. I am kind of at a builder block with this one so i just started building.