Recent content by gbryant

Never Used MW 170 $300 Used X 252 $150

Title says it all.... I've seen the post where the subs are installed in the back of the seat.... I would rather have the enclosure in the bottom ...down firing. Any help is appreciated... Thanks.

Thanks Rich!

I'm tired of wrapping up several feet of RCA cable... they are either too long or too short.

bump to top

Anyone know of a supplier of good quality parts and wire to make RCA cables? OR Supplier that sells premade cable to length.

PM Sent

It worked... after double checking phase... I set the sub amp to min, set up the Imprint, works great! Actually, my subs are much more controlled now and my system sounds real good... but, there's always ...better. Thanks all.

Thank you both for your replies. I will check my wiring for phase and ... no, I did not set the bass to 'minimum'. So... out to the garage...

My deck is an Alpine IDA-x100. I added the Imprint processor(to increase line voltage and a few acoustical problems). When I initially installed it, the sound was pretty good... mainly the subs were much better controlled. Then... I ran the software and used the Mic.... no BASS!!! The rest...

So do I...

...

So... I've had the Dyn's installed for a while.... at first I was thinking...AARRRGGHHH!!! WTF!!! So... I have played in home and car audio since I was 15, and I know most electronics and speakers need a break in period, and these do. Let me tell you, these DynAudio's just keep sounding better...

I have never had a HU that allowed turning off the internal amp...

audio control