Recent content by JSMCO

Much thanks for the input. Very appreciated!

One other question. The Pioneer speakers are 4 ohm and 100W RMS rated. The Recoil amp does 80W @ 4 ohm, and the alpine does 40W @ 4 ohm. Wouldn't both amps be underpowering the Pioneer speakers?

Thanks very much for the suggestions! They all make good sense. The only concern I'd have is I don't believe either sub option would fit under the seat as desired, but I'll do some measuring and see.

Where would be best to look for something like that?

I don't know what that is? Is it a connector with cables that would plug into the connector that goes into the amp?

Thanks for the reply! I was already looking at the same Audio Control Unit you mentioned. This would be for my daughter, she just wants better sound with more bass. Here is what I was considering: AudioControl LC7i Infinity Primus 4 channel compact amp Front Speakers-Morel Maximo Coax Rear...

Hi Guys I am considering upgrading the amp & speakers in my 2007 Honda Odyssey touring and I have a few questions. I want to keep the factory radio for the RES. I know some of these are pretty nitty-gritty. I would probably also replace the factory sub under the front seat with a compact...

Not sure if you ever figured this out but I read on the Honda Odyssey forum it may actually be coming from the VCM kicking in. This would make sense as you say it goes away when you're accelerating. Does the thumping coincide with your ECO light coming on?

I did. I considered some Focal Iss165s, Morel Maximo 602s and Polk MM6502s. I went with the Polks in the end because: 1.  The other two did not have any attenuation control for the tweeters. 2.  The Polks had a bit higher RMS handling 3.  The Polks will fit into my rear door cutouts with no...

I have a small custom fiberglass sealed box approx .5 cu ft for a 10" sub.  Two questions: 1.  How much clearance does there need to be between the bottom of the sub (the magnet) and the box wall? 2.  Has anyone ever tried using a piece of dynomat/retromat/hushpad or similar between the bottom...

Thanks for the input guys.  I stuck with separate lugs and fuses for the 4 and 8.

Hi guys.  I have a 2008 Dodge Ram Quad Cab.  Kenwood Excelon Head.  AudioControl Three.2 (For Sub Only, it actually works very well) & Matrix Plus.  Alpine PDR M65 AMP for 1 10" sub Old Boston Pro 10. Front doors are Boston SPZ60's.  Extra set of Boston Neo Tweeters in the dash, tuned down...

Thanks for the reply Carloss.  I actually ended up just buying an Alpine PDR M65 Amp which the certificate said puts out 796 watts and can run a 2 OHM sub.  The single Boston now really sounds great and it was much easier and cheaper to just swap out the amp than to have to pay for a 2nd...

I have an extra Earthquake Sound Platinum 0/1 AWG Power Ring Terminal.  It's the type with the screw in it, not the crimp type.  As long as they'll both fit in the sleeve, could I attach both a 4 AWG and an 8 AWG  power cable to this same lug?  Then each cable would go to it's own fuse holder...

Guys, I have 1 of these old Boston Pro 10.5lfs.  The 2 ohm.  It's in a small-about 0.4 cu ft sealed custom fiberglass enclosure for my dodge ram under the rear driver's side seat.  It's been running off of one side of a Rockford Punch 500s so getting 250W, according to the amp specs.  I don't...