Recent content by Shaun Beier

I did custom install and built the box myself so it is just how I want it to sound

I am running all Rockford punch and power series and I have nice clear sound. Had no issues. However i am only getting 2350 watts rms because i don't care about spl just sq

you will need 2 2 ohm subs or 2 4ohm dvc each wired in parallel to get full power. also ported box will give you a bit more bass punch.

it does 1 ohm so you could get 1200 out of it just make sure to run it at 1 ohm. i have a punch 1000bd and it runs 1497 watts rms and is about 150 dollars more so i would say it is a good deal. car audio places always push certain products so dont believe them. pioneer makes good products. i...

thanks to everyone for your input. you all have valid points. my dqdx does come with a adjustment knob connected with a cable for delay adjustments and i am going to get my friend to turn the eq dials while i sit in the front seat. this way i will get perfect sound from the drivers seat.

I am also using it for the delay system which will lift up the sound because the speakers are low in the door of my dodge journey. Also for more precise bass adjustments .thanks for the info.

i am going to buy a audiocontrol dqdx so i can increase my rca voltage to my amps up to 5 volts. i have an aftermarket jvc double din which is a little weak on rca voltage. i am running a rockford punch 1000bd at 1 ohm on two punch 12" p3d4 subs ported to 33 hz and a punch 600x4 running 4 power...

have you tried using grounding loop isolators on the rca plugs going into the dsp? it is considered a bandaid solution but i had that problem and it eliminated it. Check your ground connections also.

I have a punch 1000x2 running 2 d4p3 12" punch subs in a ported box tuned 33hz. i am running 1/0 gauge ofc power wire and have done the big 3 as well. i have an excellent ground to my seat bolt(measured less than 1 ohm from the battery for resistance) and i also have a 30 farad rockville...