Recent content by Sk8almost44

Hello! So I just purchased a new sub and I'm trying to find the perfect amp to match. Looking at this diagram I need to find a 500w at 2 ohms mono amp? I don't know if this is the correct diagram..?? This is the sub: MEMPHIS 15-MR12D4 12" dual 4 ohms Memphis Reference Subwoofers And here...

I received my amp lot plus extras, but I don't think I have the tools to cut/crimp the terminal onto the wires.. Guess I'll have to go to a shop and pay them a little to do it for me. Purchased: Amp kit 2 extra RCA sets Distribution block w/ 2 fuses 5ft 10g speaker wire AWESOME kit...

I have the same amp, got a very nice deal off craigslist. Very nice amp to power my JL door speakers. Good luck with sale!

I sent you a pm, very interested!

Okay thank you everyone, I finally hooked it back up... come to find out it DOES work, but you just have to turn the gain and bass boost waaay up to hear anything.. This doesn't seem normal..

Okay sounds good! Did I correctly match the amp/sub with both of them being @ 4ohms, the sub is 150w and the amp is 200w? I'm still not too sure how the ohms effect the watts being pushed out of the subs... For example, if I had two of these 8" subs connected, that would make them 300w @ 2...

Thank you for the fast reply, And my headunit is is an Alpine CDA-9884 and the box: CP108LG-W3v3 - Car Audio - Subwoofer Systems - MicroSub Thank you so much for helping me, I will make the adjustments with the Gain and Bass Boost.

Hello, I think I may have a good setup.. I have a Memphis PRD 500.1 amp and JL Audio 8W1v2-4 subwoofer I got a 8" sub for 3 reasons: 1. I have VERY LITTLE room in my truck 2. I have had 10", 12", and a 15" sub, so I wanted to try an 8" and see how it sounds 3. I am not looking for a lot...

Update: I rotated the top piece, and screwed the screws in all the way (tightly) and it made the cone very firm when you lightly press down. When you tap the cone, it didn't make that drum "thud" noise.. Loosened all 3 bolts a little, noticed a rub still. This fixed the firm feeling when you...

bump

Does it look bad? Before I took it apart, I noticed the 3 screws in the back were a little loose... Maybe a problem with the "thud" noise when I would tap on it. After I took it apart, rotated it, and tightened the 3 bolts it still has the rubbing noise. Also when I tap on it, it still...

I had an amp installed/hooked up before I switched to this amp, and was providing sound. All connections are good because when I removed the amp and put the previous amp back in I had sound again.. Yes I have tested the subs, I had an amp very similar installed previously to this amp, and I...

Sorry they may be a stupid question, but how do I remove the top? Thank you so much!

Bump

Bump