Recent content by Tiptopss

A pic of what my kenwood amp looks like

My kenwood kac-929 1000W, 2 channel amp. Had that bump n for many many years and still works great. Time for a mono block amp soon though.

Fu@k! A 12" sub weighs 71 pounds?

I feel sorry for your ears lol That setup will be bang n

So if the Amp I bought says 500 x 1 rms at 2 ohms, does that mean it will put 500 rms to each sub? Or would that be cut in half to 250 rms? Sorry for the non understanding as I'm not use to monoblock amps and 2 ohm loads. I always just ran 4 ohm subs on 2 channel amps

That amp Jimi77, is there specs for 2 subs? Looks like in that description is only for x1

So on a monoblock amp you have 4 speaker wire connections? 2 connections side by side is positive and the other 2 that are side by side are negative? If I wire my subs parallel and only have 2 wires coming off my subs where do I attach them? Does it matter? Or wire them like a bridged connection?

I have a pioneer HU with 4 gauge power and ground wire. I currently am running 2, 10 inch subs on a kenwood kac-929 2 channel amp. That amp is sending 150 x 2 rms to each sub at 4 ohms. I don't think I can wire my svc subs in parallel for 2 ohms and run that setup bridged. It however says 230 x...

Hi, looking for a bit of info on an amp. I have 2, 10 inch pioneer subs rated at 800 watts each or 400 rms watts each. I'd like to find an amp that will put 300 Rms watts to each sub. Would my best bet be to wire my 4 ohm single voice subs in parallel to make it 2 ohms? If so what kind of amp...