Recent content by watcher6342

also have this coming to help with the lack of any carpet padding.....Speedway Motors Aluminized Heat And Sound Insulation Shield, 46 Inch By 75 Inch

i have another question.. i have the ct sound ct-150-4D amp, to run front speakers. PowerBass OE-652 are 2 ohm speakers. amp says it can run them. does anyone have any experience with these speakers? i have already done killzmat and foam. am ripping out rear deck speakers as we speak. running...

i think i found a thread that explains it , it just doesnt say about 2 amps, but i think i have the gyst. is it better to have a separate ground for the rear battery, rather than tying it in with the other ground. is it safer?

sorry for the spelling , small phone and sunshine.

will be running this vertical behind sub box , right behind rear seats. i also will be building a cooling box with 4 4 inch fans, 2 push and 2 pull, they will probably be facing up towards the rear deck, so i have room for adj on the settings of each amp. the abs will probably be screwed to a...

i just ordered 2 more inlines and 2 more dist blocks just in case.

if you can post a rough drawing, it would probably make more sense to me. thanks

im having some trouble on the layout and how to run the wires. i have the taramp mono and the ct 4x..i have 2 dist blocks and 2 inline fuses, also a secondary dist block for leds and fans. i am unsure if i have to run inlines to the sec battery and then come off of that and then split pwr at...

im trying to figure out how to get a set of lift struts to go onto my sentra trunk lid. i tried the springs from amazon, but they are not strong enough or short enough. i wanted to know if anyone has ever modified their car trunk lids with lifts, after theirs had tension rods? thanks

why does my bass keep cutting out, while volume is at 10, but usually kicks in if i double the vol. is it some type of safety thing?

we had close to 3 inches of rain over the weekend. thats 2 weekends in a row that i have been shut down. still waiting for alternator and screw it kit, before i can start the layout

no kidding. i just need some for the box i will build , probably behind the sub box. i bought a 3/4 inch drill bit, that should be large enough to get multiple cables through the same hole.

ordered that kit, home depot was wanting $2+ for a single grommet.

excellent, thats what i was looking for. thanks

nvrmnd, i found some desk cable grommets that should work. i just dont want to run speaker and amp wires through something that has rough edges.