Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Abarth 500 amp and sub bypass anyone?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="1aespinoza" data-source="post: 8837983" data-attributes="member: 654802"><p>First you have to figure out if the OEM amp is for the entire system or just the sub. If just for the sub, you will splice behind the radio with the speed 9 wire. The harness you buy will come with bare wires to connect the speaker high outputs from the new radio. You will connect the speed 9 to these wires. You will tape off the speaker high outputs from the radio since you will not use OEM amps.</p><p> If the OEM amp powers the entire system, you will do this splicing right after the amp. Google "Abarth 500 radio/amp pinout" to find which wires go to each speaker. </p><p> Then connect RCAs, power, ground, and remote signal.</p></blockquote><p></p>
[QUOTE="1aespinoza, post: 8837983, member: 654802"] First you have to figure out if the OEM amp is for the entire system or just the sub. If just for the sub, you will splice behind the radio with the speed 9 wire. The harness you buy will come with bare wires to connect the speaker high outputs from the new radio. You will connect the speed 9 to these wires. You will tape off the speaker high outputs from the radio since you will not use OEM amps. If the OEM amp powers the entire system, you will do this splicing right after the amp. Google "Abarth 500 radio/amp pinout" to find which wires go to each speaker. Then connect RCAs, power, ground, and remote signal. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Abarth 500 amp and sub bypass anyone?
Top
Menu
Home
Refresh