Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
Amp turns on, but no sound
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Aniallation" data-source="post: 8488660" data-attributes="member: 669424"><p>I wouldn't imagine that hooking it up to the wrong set of preouts would make it get no sound at all. Worst case would be hooking it up to the front/rear output rather than the subwoofer output, and getting a full-range signal sent to the amp instead of one with a LPF applied.</p><p></p><p>OP: did you make sure all connections are correct and properly attached? RCAs going from receiver to amp, speaker wires from amp to box, and wires on the inside of the box from the terminals to the woofers.</p></blockquote><p></p>
[QUOTE="Aniallation, post: 8488660, member: 669424"] I wouldn't imagine that hooking it up to the wrong set of preouts would make it get no sound at all. Worst case would be hooking it up to the front/rear output rather than the subwoofer output, and getting a full-range signal sent to the amp instead of one with a LPF applied. OP: did you make sure all connections are correct and properly attached? RCAs going from receiver to amp, speaker wires from amp to box, and wires on the inside of the box from the terminals to the woofers. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
Amp turns on, but no sound
Top
Menu
Home
Refresh