Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Big 3 location help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="maylar" data-source="post: 8129497" data-attributes="member: 541144"><p>I have always had good luck using self-tapping screws for grounds. You need to drill the pilot hole just the right diameter so the screw has something to bite into otherwise it'll be loose. The screw should require a ratchet to drive it in. Tight but not stripped... takes experience to judge that. If you can get to both sides, obviously a bolt and nut is much better.</p><p></p><p>I also use a lock washer (internal or external tooth star washers are better for this than split-locks). The lock washer goes between the terminal and the vehicle body, not under the screw head. Ideally you want to secure the wire with a tie-wrap to something so the wire doesn't move and make the connection loose over time. Follow up with paint or dielectric grease to keep the connection from oxidizing.</p><p></p><p>Materials don't matter much here - I use steel hardware and plated copper terminals.</p></blockquote><p></p>
[QUOTE="maylar, post: 8129497, member: 541144"] I have always had good luck using self-tapping screws for grounds. You need to drill the pilot hole just the right diameter so the screw has something to bite into otherwise it'll be loose. The screw should require a ratchet to drive it in. Tight but not stripped... takes experience to judge that. If you can get to both sides, obviously a bolt and nut is much better. I also use a lock washer (internal or external tooth star washers are better for this than split-locks). The lock washer goes between the terminal and the vehicle body, not under the screw head. Ideally you want to secure the wire with a tie-wrap to something so the wire doesn't move and make the connection loose over time. Follow up with paint or dielectric grease to keep the connection from oxidizing. Materials don't matter much here - I use steel hardware and plated copper terminals. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Big 3 location help
Top
Menu
Home
Refresh