Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Headway building 101
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Wesseat" data-source="post: 8817315" data-attributes="member: 683916"><p>I've watched videos where guys hook all the cells together in parallel then let them set overnight and balance. Then they take a DC voltage Supply and charge all cells still in parallel to 3.5. Then with eyes on they slowly bring the voltage on up 3.65 then disconnect the cells and let them set overnight and check the voltage and see if you have any bad cells, if not then assemble your bank. I've seen other videos where guys skip the charging with the DC power supply 3.65 volts and they balance then assemble the bank and then charge it to 14.6volts with a 5 amp lithium charger... I had another guy tell me if they're new just assemble them with your bars and put them in your car and let the alternator charge them.</p></blockquote><p></p>
[QUOTE="Wesseat, post: 8817315, member: 683916"] I've watched videos where guys hook all the cells together in parallel then let them set overnight and balance. Then they take a DC voltage Supply and charge all cells still in parallel to 3.5. Then with eyes on they slowly bring the voltage on up 3.65 then disconnect the cells and let them set overnight and check the voltage and see if you have any bad cells, if not then assemble your bank. I've seen other videos where guys skip the charging with the DC power supply 3.65 volts and they balance then assemble the bank and then charge it to 14.6volts with a 5 amp lithium charger... I had another guy tell me if they're new just assemble them with your bars and put them in your car and let the alternator charge them. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Headway building 101
Top
Menu
Home
Refresh