Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
KHA 2023 SS Camaro - SQ Build Log
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="keep_hope_alive" data-source="post: 8855862" data-attributes="member: 576029"><p>Good question and I realized that I didn't include pictures of the CLD on the metal as the first step, before the insulation. I added patches of CLD on the exterior sheet metal until sufficient damping was observed. I don't worry about 100% coverage on the exterior panels when the void is fully stuffed with insulation. The interior metal surfaces will get close to 100% where they can be excited by speakers (i.e. the rear deck, doors, etc.). I knock on the metal surfaces to listen to resonance and add CLD until I'm happy with the resulting tone and duration.</p></blockquote><p></p>
[QUOTE="keep_hope_alive, post: 8855862, member: 576029"] Good question and I realized that I didn't include pictures of the CLD on the metal as the first step, before the insulation. I added patches of CLD on the exterior sheet metal until sufficient damping was observed. I don't worry about 100% coverage on the exterior panels when the void is fully stuffed with insulation. The interior metal surfaces will get close to 100% where they can be excited by speakers (i.e. the rear deck, doors, etc.). I knock on the metal surfaces to listen to resonance and add CLD until I'm happy with the resulting tone and duration. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
KHA 2023 SS Camaro - SQ Build Log
Top
Menu
Home
Refresh