Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
problem after wiring second batt
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="hansk" data-source="post: 6828324" data-attributes="member: 619351"><p>i added a yellow top in the rear yesterday and did the big three. i wired the second batt in parallel + to + and - to - then ran my power to the amp off the rear positive. after i hooked everything up i noticed the the red batt light on the dash below the check engine like was glowing red and the emergency brake light stays on even when its off and these didn't do it before i installed everything... and on top of that my power steering when out (i know it doesnt have anything to do with the batts but just wanted to add that too...lol) any suggestions why the light would still be on?? Oh and my check engine light is on too but that was already on before i installed everything...... oh and before i installed the batt it read12.8 of the ddm and after i installed it with the car running it red 14.6 or 14.8 something like that i cant recall off the top of my head.</p></blockquote><p></p>
[QUOTE="hansk, post: 6828324, member: 619351"] i added a yellow top in the rear yesterday and did the big three. i wired the second batt in parallel + to + and - to - then ran my power to the amp off the rear positive. after i hooked everything up i noticed the the red batt light on the dash below the check engine like was glowing red and the emergency brake light stays on even when its off and these didn't do it before i installed everything... and on top of that my power steering when out (i know it doesnt have anything to do with the batts but just wanted to add that too...lol) any suggestions why the light would still be on?? Oh and my check engine light is on too but that was already on before i installed everything...... oh and before i installed the batt it read12.8 of the ddm and after i installed it with the car running it red 14.6 or 14.8 something like that i cant recall off the top of my head. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
problem after wiring second batt
Top
Menu
Home
Refresh