Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Speakers
Speaker help.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="kouger" data-source="post: 8855363" data-attributes="member: 689597"><p>Thank you so much for your feedback. </p><p>I definitely don't want to change out the system or add anything to it other than replacing the speakers.</p><p>The only reason I thought about changing the doors and the dash were because I thought if I can only get 4 ohms for the dash then possibly changing the doors as well would balance out the volume to some degree.</p><p>Your explanation makes a lot of sense to me.</p><p>This is what I have:</p><p>Center dash - 2.2 ohms. Does not look like there is a capacitor and looks like there is NO tweeter - just a cone.</p><p>Dimensions:</p><p>4" Diameter</p><p>Screw holes 5.25" diameter</p><p>Depth - 2"</p><p>Magnet size - 1.375" diameter</p><p></p><p>Side dash - 2.2 ohms measured from the connector that goes to the amp/radio. There is a capacitor and when testing across that I get a reading of 6.2 ohms</p><p>Dimensions:</p><p>3.25" Diameter</p><p>Screw holes 3.625" diameter</p><p>Depth - 1.75" however the wire connector is attached to the bottom of the magnet and increases the depth to 2.5"</p><p>Magnet size - 1.375" diameter</p><p></p><p>I did go to a salvage yard (actually 2 of them) and could not find anything. Then again I was only looking at Hyundai and Kia.</p><p>The only things I found were speakers that did not have a tweeter in them. They were just cones. I did buy a set to test but the sound was worse than what I have.</p><p></p><p>I have removed the blown speaker as well as the center dash. The problem I have now is that when I make a phone call, the voice comes through on the other dash speaker and it sounds terrible. There is a lot of distortion unless I turn the volume down quite a bit. But then I can't really hear the person speaking. I know when the center dash and the other side dash is installed it plays through all 3 of them. </p><p></p><p>I appreciate all your feedback. Thanks</p></blockquote><p></p>
[QUOTE="kouger, post: 8855363, member: 689597"] Thank you so much for your feedback. I definitely don't want to change out the system or add anything to it other than replacing the speakers. The only reason I thought about changing the doors and the dash were because I thought if I can only get 4 ohms for the dash then possibly changing the doors as well would balance out the volume to some degree. Your explanation makes a lot of sense to me. This is what I have: Center dash - 2.2 ohms. Does not look like there is a capacitor and looks like there is NO tweeter - just a cone. Dimensions: 4" Diameter Screw holes 5.25" diameter Depth - 2" Magnet size - 1.375" diameter Side dash - 2.2 ohms measured from the connector that goes to the amp/radio. There is a capacitor and when testing across that I get a reading of 6.2 ohms Dimensions: 3.25" Diameter Screw holes 3.625" diameter Depth - 1.75" however the wire connector is attached to the bottom of the magnet and increases the depth to 2.5" Magnet size - 1.375" diameter I did go to a salvage yard (actually 2 of them) and could not find anything. Then again I was only looking at Hyundai and Kia. The only things I found were speakers that did not have a tweeter in them. They were just cones. I did buy a set to test but the sound was worse than what I have. I have removed the blown speaker as well as the center dash. The problem I have now is that when I make a phone call, the voice comes through on the other dash speaker and it sounds terrible. There is a lot of distortion unless I turn the volume down quite a bit. But then I can't really hear the person speaking. I know when the center dash and the other side dash is installed it plays through all 3 of them. I appreciate all your feedback. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Speakers
Speaker help.
Top
Menu
Home
Refresh