Recent content by Justintoxicated

  1. J

    DLS Irridiums Tweeter Cutting Out

    I have been having some issues with my DLS irridiums.  If I turn the system up loud enough the tweeter will start playing again, and I can then turn it back down and it will continue to play.  Then if the vehicle sits for a week, the next time I turn the stereo on the tweeter won't work until I...
  2. J

    They don't make them like they used to? (2005 era)

    Also, slightly off topic but I think one of my passive crossovers for the DLS components might be acting up.  When I had the fronts amped I would have to turn up the volume kinda loud to get the tweeter to start playing, and then it would play fine for the rest of the trip with 0 issues. Now...
  3. J

    They don't make them like they used to? (2005 era)

    There's actually air around the amp (except the very center and one other place that touched), but it had a pretty light load on it anyways (Just the 2 TC 1000's).  Anyone remember what config they typically were?  I think dual 4 ohm coils wired for 2 ohms then wired in parallel, so there was no...
  4. J

    They don't make them like they used to? (2005 era)

    Think it's worth pulling the Eclipse CD3200 out too and replacing with the factory stereo? I could also pull off the front door panels and remove my DLS Iridiums?  Would it be worth it? The one issue I have with the CD7200 MKII  is that I have to manually sync my phone to the unit(well most of...
  5. J

    They don't make them like they used to? (2005 era)

    I haven't been into the car audio seen in years because I still have my truck, amps and CD player from when I installed them years ago.  Everything still works perfect.  Need some help figuring out what to keep and what to get rid of. But it's time to sell my truck and I figure I may as well...
  6. J

    Kinetik Dead, Need a new battery

    measured the voltage when I got home from work and it was at 12.78v. Decided to try it in the truck so I installed it and the truck started right up, no needles bouncing around etc. I tried starting it 3 times (once with the headlights on) and it started right up without hesitation. Turned...
  7. J

    refoaming a 5.25" speaker questions

    I was hoping to use them for surround speakers. The problem with replacing hte woofer is I would then need to replace the crossover and tweeter as well, so I may as well just buy a new pair. Would the 10htz tone method work with a regular speaker or does this only work with subs?
  8. J

    refoaming a 5.25" speaker questions

    I was reading something about playing a certain tone or something to help with alignment but I don't know if this works for speakers. It sounds like I may be better off just buying new speakers then, Its just a shame to throw out these oak cabinets etc.
  9. J

    refoaming a 5.25" speaker questions

    I inherited some infinity SL10 speakers *(home audio) that had been store din my dads shed for a few years. Of course in the Hot California sun it pretty much baked the surrounds dry and they disintegrated when I plugged them in. They are not super expensive speakers or anything but for $20 I...
  10. J

    Kinetik Dead, Need a new battery

    So The regeneration finished and then It took a couple hours for the charger til top off the battery to full. Voltage off the charger was a about 13.12v Measuring the battery this morning and it had dropped to 12.8v. I will get another voltage reading tonight before I put it back in the...
  11. J

    Kinetik Dead, Need a new battery

    Interesting, the instructions that came with my charger specifically said to charge it for up to 20 minutes before using the desulfate mode. Should I not have charged the battery?
  12. J

    Kinetik Dead, Need a new battery

    It sounds like the Battery tender plus will not work well for the kinetik? The Battery Tender Plus has a float voltage of 13.2v and the kintetik suggests 13.5v-13.8v (Or is that close enough? better than letting it sit?)
  13. J

    Kinetik Dead, Need a new battery

    Battery is running the desulfate mode on the charger. I'm not sure what you meant about the voltage on the maintainer? The instructions do not really go into great detail, other than that I should charge the battery for 20 minutes before restoring the battery and some general guidelines. I'm...
  14. J

    Kinetik Dead, Need a new battery

    I ordered the kinetik charger with the desulfator option. I found my Knu Koncepts battery terminal had worked very slightly loose over the last 4 years. I have the chrome battery terminals as I kept stripping the lead ones when tightening down all my connections. There was virtually no...
  15. J

    Kinetik Dead, Need a new battery

    Good points, but lately fixing and moving into my new house has taken priority to my cars and trucks, I have very little free time, maybe I'm even considered a workaholic but I do my best and try to keep up. I have always wanted a charger but it was its just low on my list of priorities. So for...
Top