Recent content by k.bean

Alright thank you for your help. I will reset the gains to 34.6VAC

When testing for the voltage... what 2 connections do I want the DMM probes in? Does it matter? Amp looks like this: - + - +

Oh I see, I thought that since there are two seperate speaker connections it would be giving 300 to each connection. But you're saying if I find the voltage for 657 and then set it so that comes out of one terminal, then it will turn into about 300 to each speaker when i hook them back up?

I have a mono amp rated at 657 watts @ 2ohms with two SVC subs wired to it. The amp has two sets of +/- speaker connections and is internally wired in parellel. I want to send 300 watts to each of my subs. When I set my gains I used a DMM and put the probes into the left set of speaker...

Did you say you'd take trades only and no cash?

pm sent.

pm sent

I want this amp, let me know if you have one and what kind of condition it's in.

Nobody else wants to throw some ideas around?

Seems to me like sanding down the blobs and then painting over would get the job done... Sanding the whole box probably isn't necessary. Roughing it up a bit might make the paint stick a little better, but I think it would probably be fine without it. Either way, paint is usually pretty...

Haha yes I love my trunk, but so far haven't been able to put it to good use. And no, I have been reading up on fiberglassing. Not sure if it is the route I want to go though. How much do you think it would cost? I really like how some of the enclosures turn out though, those rounded edges...

Off to work, I'll be back to see what you guys have come up with later tonight. P.S. I don't see why there are like 30 views and 5 posts... I'm sure everyone has an opinion, post it!

Keep the Michelob box, no question.

Hehe.. It's my real last name

Probably rip out the plastic on the sides and put wood there eh? What about having like 1/2" mdf for structural strength with like a thin sheet of a sexy grain wood on top?