Recent content by Perdonic

and on some you don't have to use rca's to connect both amps, only one set going in to the primary amp. Then find the manual to see how you wire the speaker terminals.

Solo x 12 for $400.BNIB 0/1awg Stinger Pro kit for $60.00BNIB

ok works now:eyebrow: , it wangs hard now that the amps are strapped, will get video.

they are not strapped they are run one amp to each coil, and set with a DMM, but when I went to set the one, it gave me no output.

yeah just the one don't work, it powers up, but goes into prtection and then comes off protection no matter where the gain is set, but that don't matter because the gain nob don't work lol, I have no output on the amp.

Well today I went to set the gain I just wired up the install, and one of my kx1200.1's don't work, it powers up and everything but when I start to raise the gain it goes into protection. I was going to set it with a DMM. the question is: I am getting no output from the speaker connections on...

it is at 4 cubes tuned to 36hz.

I got one off here had it for about a month or 2 and had the other one for awhile about 6-7months, sorry i want straight cash.

it don't seem that loud to me, did i over estimate the sub, hmmmmm.

they wouldn't last long at .5ohms.

For both or one... And I don't have paypal, bump.

Ok so I have 2 kx1200.1 strapped to a 12 inch solo x DVC 1ohm, everything is in my sig, question is would I benefit from going to a orion 2500D run at .5ohms, would I really notice the difference.

bump i want to sell as a pair, at .5ohms a orion would slaughter these. I don't have paypal. Or a trade for a really good condition orion 2500d and some cash.

Reason for selling is I need more power, I want a orion 2500D to run the solo x at .5ohms. These amps are in pretty good condition, and work really well, Just don't really get my sub bumping the way I want it to. They both are rated at 1400RMS@1ohm benched. have one bass knob have the strap...

I think i should have went abit bigger, I don't know when the iraggi's start really charging, but i do know that when i rev to 1500 the voltage jumps right up to 14.40-13.80 on test tone so i would think from 1200-2000 somewhere in there for rpm's. car on and 36hz test tone in and gain on half...