Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Alpine Install problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="tvro32" data-source="post: 6626290" data-attributes="member: 618764"><p>I have just installed a new alpine amp MRP-F300 with a pair of Alpine SPR-17C 6 1/2 2 way coaxial speakers. We used the speaker level inputs form the head unit. (BMW 325i 1994). At very low volume the system works great. But when turned up (Normal levels) the amp cuts out for 10 seconds then plays for several seconds before cycling again. The power feeds for the amp are 8 ga less tha 3 feet direct to battery. If I connect a pair for 6X9 8 ohm speakers to the amp (same channel) everything works great. The alpine speakers are listed as 4 ohm. Why would they trip the protection circuit in the amp?</p></blockquote><p></p>
[QUOTE="tvro32, post: 6626290, member: 618764"] I have just installed a new alpine amp MRP-F300 with a pair of Alpine SPR-17C 6 1/2 2 way coaxial speakers. We used the speaker level inputs form the head unit. (BMW 325i 1994). At very low volume the system works great. But when turned up (Normal levels) the amp cuts out for 10 seconds then plays for several seconds before cycling again. The power feeds for the amp are 8 ga less tha 3 feet direct to battery. If I connect a pair for 6X9 8 ohm speakers to the amp (same channel) everything works great. The alpine speakers are listed as 4 ohm. Why would they trip the protection circuit in the amp? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Alpine Install problems
Top
Menu
Home
Refresh