robertark 10+ year member
Alpine Fan
Hey guys,
I had these subs hooked up in my room before I took them out to my car. I have a Kinetik HC1800 that I used in my room and a spare deck. Wired it all up with 0ga wiring (pos to pos, neg to neg) and it worked. About blew my door down.
Now, I get it all outside, wired, perfect voltages, etc, and nothing. The subs are wired to the amp correctly and the amp comes on. No sound. Since it was in my car with a different deck, I figured it could be a bad deck or interconnects, so I brought out the old deck and hooked it up even using different interconnects. Still nothing. So, the amp is getting a signal in, but it's not putting anything out - at all.
Is there a way, with a voltmeter, to test the amp's mono out? Maybe even the resistance (ohms)?
I can't figure this out and I've been going at it for a while now. Suggestions would be great,
Rob
I had these subs hooked up in my room before I took them out to my car. I have a Kinetik HC1800 that I used in my room and a spare deck. Wired it all up with 0ga wiring (pos to pos, neg to neg) and it worked. About blew my door down.
Now, I get it all outside, wired, perfect voltages, etc, and nothing. The subs are wired to the amp correctly and the amp comes on. No sound. Since it was in my car with a different deck, I figured it could be a bad deck or interconnects, so I brought out the old deck and hooked it up even using different interconnects. Still nothing. So, the amp is getting a signal in, but it's not putting anything out - at all.
Is there a way, with a voltmeter, to test the amp's mono out? Maybe even the resistance (ohms)?
I can't figure this out and I've been going at it for a while now. Suggestions would be great,
Rob