I installed a kenwood stereo yesterday in my Frontier. Everything was working fine. I connected the basics. No mute, no dimmer, just the speakers and power supply. Today My headlights turn on fine but the gauge cluster/ instrument panel will not illuminate. Any ideas on what could have gone wrong?
-
2Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
If you buy a replacement OEM Radio Harness the colors will match up then you can use a wiring harness to connect to that. According to a few...
- Started by Mike Hunt
- Wiring, Electrical & Installation
I use the small metal screwdrivers made for electronics.
- Started by amadeusradio
- Wiring, Electrical & Installation
I'm guessing that's what it is. There's not a lot of room back there.
- Started by chillin
- General Car Audio
About this thread
New threads
-
Another VS ThreadLooking to go for a cheap SQL build in the back of my Jeep...
- Started by Blackout67
- Replies: 16
-
Running two pairs of component speakers activeHello everyone. I need some advice. I am considering...- Started by 6r33n3y3z
- Replies: 10
-
Im trying to hook up a 4 channel ampI currently have a stock head unit with stock amp with jbl...- Started by William Melcic
- Replies: 2
-
Chrysler 300 Dual Battery/350A ALT Connection Help Needed.Hello, New member here. Intermediate knowledge, four...- Started by Virtuous Warrior
- Replies: 3
-
21 Ram 1500Ill try to keep it short. “Base 6 speaker system”. I upgraded...- Started by Dylansnut
- Replies: 1