SOLD FS: 3k rms amp- 18" psi sub ( 3k rms) 25+ ft 1/0- rcas

BushJ311
5,000+ posts

CarAudio.com Veteran
7,773
0
NW, PA
Powerbass xa 3000d- was repaired and has worked perfect ever since. i have only ran it at 4 ohm. 2 ohm for a day or two.

18" sub. konaki motor. built by team psi. handles 3k rms. d2 coils. double leads. used for under 3 weeks.

around 18ft monster 1/0

7 ft knu flex

a bunch of smaller runs of kollusus

some welding cable with rings on end for big 3. will measure it all tomorrow

2 sets of stinger venom rcas 20 ft.

1000 or b/o for all of it. ( make offers on separate items)

Would rather split it up. will try to get prices for each separate tomorrow.

425 amp

350 sub

rcas 15 each

1/0 2-3 a ft

 
kb2.jpg


kb3.jpg


kb6.jpg


Blazer031.jpg


Blazer029.jpg


 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

It won't power that sub anywhere near its full potential, but you can connect them.
10
2K
Thank you guys! I will lower the gains with the multimeter as I have watched the youtube.
5
1K
Set the voltage to 20 volts via DMM and it will equal out to around 100 watts. https://www.the12volt.com/ohm/ohms-law-calculators.asp#voltage
4
1K

About this thread

BushJ311

5,000+ posts
CarAudio.com Veteran
Thread starter
BushJ311
Joined
Location
NW, PA
Start date
Participants
Who Replied
Replies
31
Views
1,655
Last reply date
Last reply from
BushJ311
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0
Screenshot_20240531-022053.png

1aespinoza

    May 31, 2024
  • 0
  • 0

New threads

Top