how do i wire a memphis 500d to 2 jlw3 dual 4

[<Memphis amp help>]

I have a memphis 500d amplifier. it is a mono block amp but has two speaker outputs(wired in paralell inside the amp). I need to know how to wire 2 jlw3's into a two ohm load so i can get the full power out of my amp. The amp is not one ohm capable. Can someone help me?

Click to read more...

 

[Matt 10+ year member]

with 2 jlw3's lookin at 1.5 to 6 ohm. adding a 3rd jlw3 you can reach the 4 ohm load. check out

http://www.jlaudio.com/subwoofers/pdfs/detailedpdfs/W3/10W3dB.pdf

on the bottom of the page is where they have the wiring configuration. Good Luck