Seperate Chambers
- Thread starter SasquatchBump
- Start date
- Replies 1
- Views 954
-
2Participant count
-
Participant list
-
SasquatchBump
In general I would say go with the seperate chambers just because the calculations to figure out the port diminsions are extremely complicated from what I have heard/seen. You have to account for a few other variables as I understand/don't understand. Other than that, I see no other reason.
Activity
No one is currently typing a reply...
Similar threads
You can run the SVC subs on the GM-DX871 at 1 Ohm, just lower the gain at the amp. The third sub is too different to run on the same amp as the...
- Started by E39.Saucyassbo.510
- Wiring, Electrical & Installation
About this thread
New threads
-
Another VS ThreadLooking to go for a cheap SQL build in the back of my Jeep...
- Started by Blackout67
- Replies: 14
-
Running two pairs of component speakers activeHello everyone. I need some advice. I am considering...- Started by 6r33n3y3z
- Replies: 10
-
Im trying to hook up a 4 channel ampI currently have a stock head unit with stock amp with jbl...- Started by William Melcic
- Replies: 2
-
Chrysler 300 Dual Battery/350A ALT Connection Help Needed.Hello, New member here. Intermediate knowledge, four...- Started by Virtuous Warrior
- Replies: 3
-
21 Ram 1500Ill try to keep it short. “Base 6 speaker system”. I upgraded...- Started by Dylansnut
- Replies: 1