speaker and amplifier compatibility

  • 2
    Participant count
  • Participant list

syracuseavionics

CarAudio.com Newbie
I have a long van and I am installing eight (8) Kenwood KFC-1795PS, 4 OHM, 88W RMS, 3 way speakers and a Planet Audio Anarchy 800W, 4 channel, 2/4 OHM Amplifier. What is the best way to wire this set-up to get optimum impedance matching and reasonable power output
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

for my amp ground I have it to the paneling in my trunk, secured with a bolt and a nut. I sanded as much as I could, and I used a grind wheel on...
72
6K
Hmm. Maybe so. Ive never been more alert driving/riding than being on a Cycle man. Several think you just get on and ride away. A good set of...
26
5K
Yes. Only thing is the leads will be encased in resin. Keep in mind that this is an assumption.
3
247
I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
6
340
Speaker ratings are generally a thermal/mechanical limitation of the drivers. Music is dynamic, not continuous. During quiet periods a song, you...
4
318

About this thread

syracuseavionics

CarAudio.com Newbie
Thread starter
syracuseavionics
Joined
Location
atlanta
Start date
Participants
Who Replied
Replies
1
Views
558
Last reply date
Last reply from
Popwarhomie
1715565471722.png

Doxquzme

    May 12, 2024
  • 0
  • 0
IMG_5880.jpeg

Brendon Jenness

    May 11, 2024
  • 0
  • 0

New threads

Top