t600-2 and 10w7

[bhill618 10+ year member]

I am looking to buy a 10w7 and run it with my rf t600-2 amp....would this amp overpower it?

Click to read more...

 

[gunz4me 10+ year member]

If you know how to set your gains, you will be fine with that amplifier on a 10w7.

 

[got-one-eight 10+ year member]

I would think the sub could take it just fine although it does put that amp at a 3ohm mono load. Long as the amp can take it I'm sure you will be fine. I have a JL 500/1 on my 8W7 and they say those amps do like 800W//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[bhill618 10+ year member]

ya my amp is 2ohm stable

 

[cotjones 10+ year member]

I would think the sub could take it just fine although it does put that amp at a 3ohm mono load. Long as the amp can take it I'm sure you will be fine. I have a JL 500/1 on my 8W7 and they say those amps do like 800W//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

actually they usually bench 700-750.

 

[gunz4me 10+ year member]

actually they usually bench 700-750.

Also, they generally bench higher on a reactive load at a single frequency versus a dummy load while driven from 5 to 250 Hz simultaneously. Remember, they are rated to provide 500 watts RMS at the latter part of the previous statement (5 Hz to 250 Hz on a pure resistive dummy load). Why everyone gets so excited when an amplifier produces more than rated power at a single frequency on a reactive load, I'll never know.//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif