Amp suggestions please

  • 3
    Participant count
  • Participant list

Haymaker

CarAudio.com Newbie
I’ll be running 3 Sundown sa6.5 sw D4. So I can go .67 or 2.67 ohms. Budget $3-400
Last system was a DDM3B on 2 DD 9510’s and later 2 zv3 10’s both ran at half ohm daily. So I know how to make an amp happy below 1 but I’ve been out of the loop for 3 years so I haven’t kept up the latest.
I thought about the Taramps bass 1200 2 ohm but have never ran a full bridge amp. I’ve always ran Koreans and beat them like they owed me money.
 
I’ll be running 3 Sundown sa6.5 sw D4. So I can go .67 or 2.67 ohms. Budget $3-400
Last system was a DDM3B on 2 DD 9510’s and later 2 zv3 10’s both ran at half ohm daily. So I know how to make an amp happy below 1 but I’ve been out of the loop for 3 years so I haven’t kept up the latest.
I thought about the Taramps bass 1200 2 ohm but have never ran a full bridge amp. I’ve always ran Koreans and beat them like they owed me money.
Korean won't let you down go M3b @ 2.67 should make them hammer
 
Wish I still had that amp.
This is going in a Ram 3500 so space is at a premium
If you're looking to make the switch to full bridge check out the Sundown lineup. Priced right, small footprint, and Sundown warranty/support.
DO NOT run them below rated impedance under any circumstances!
 
Looks like the sundown SFB 2000 would be a pretty good match. Probably be right around 1200 at 2.6 ohms @13-14v wouldn’t it?

  • SFB-2000D Monoblock 2000W RMS Amplifier
  • Power Handling:
    • RMS Power at 14.4V DC 1 ohm Mono: 2350-watts
    • RMS Power at 14.4V DC 2 ohm Mono: 1520-watts
    • RMS Power at 14.4V DC 4 ohm Mono: 950-watts

 
Looks like the sundown SFB 2000 would be a pretty good match. Probably be right around 1200 at 2.6 ohms @13-14v wouldn’t it?

  • SFB-2000D Monoblock 2000W RMS Amplifier
  • Power Handling:
    • RMS Power at 14.4V DC 1 ohm Mono: 2350-watts
    • RMS Power at 14.4V DC 2 ohm Mono: 1520-watts
    • RMS Power at 14.4V DC 4 ohm Mono: 950-watts
Sounds about right at running voltage ...
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Pretty much. It's just a nice kit. A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
10
848
Hahaha his brother got some from a friend. American bass amp and some alpine s 12in subs. From a buddy of his now Eastons chomping at the bit...
9
846
Hi guys, I’m John. Been out of car audio for probably 15 years or so. I built a couple boxes back in the day and was definitely a bass head but...
0
1K
I really like to run the old Autoteks.. BTS and Mean Machines. Its hard to pull like the USA US Acoustics 2150s off the fronts and trynew. They...
26
4K
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
159

About this thread

Haymaker

CarAudio.com Newbie
Thread starter
Haymaker
Joined
Location
Florida
Start date
Participants
Who Replied
Replies
5
Views
678
Last reply date
Last reply from
Louisiana_CRX
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top