Amplifier power raised

I have 2 jl w3v3 10-4 subs wired parallel to 2 ohms with a lanzar vector 800 watt amplifier. After I got the amplifier I looked at the specs on it and it said it only put out 275 watts at 2 ohms which means that only about 138 watts are going to the subs. It can handle 500 watts rms, so if I got a new amplifier that could fully power the subs, how much louder would they be?

 
Probably a decent bit louder. But more importantly it should save the speakers from having the coils burnt up.
Under powering a sub will never burn it up. A ton of distortion and dirty power from a cheap amp can kill them from creating excess heat. But yes going from 275 watts thats probably not clean to a clean 1000 or more, you will tell a huge difference.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Like @maylar said, delay the turn on to the amplifier only. 3 to 5 seconds should take care of it.
8
404
Google and Ebay are your friends. Froma quick search and providing these are like new, $2- $400 for the subs and $2- $400 for the amplifiers...
1
257
The CT's are nice, That Sundown is a a frik'n beast!
7
879
I would try a pair of Bass Blockers on the rear speakers. I always place them on Coax. speakers generally, Should help quite a bit I like PAC ones...
3
870

About this thread

Thread starter
Cbglasscock
Joined
Location
Hoover,Al
Start date
Participants
Who Replied
Replies
2
Views
409
Last reply date
Last reply from
Dub7sonoma
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top