Box Build for SVTLightning01

I couldnt do that to a lightning. I figured someone else who could afford it would drive it as it was meant to be.

400whp/495tq sure was fun though. 10mpg wasnt. $104 for 270-300 miles hurts the pocket as much as i drive to vegas to see the folks.

 
you doing a e85 conversion?
I dont know much about it, but its a new technology that i wont gamble a 8k motor on something that isnt proven.

Good luck to you though!
I researched e85 and it actually hurts your gas mileage! its just some stupid go green ****.

What Im doing has been tested plenty of times but people keep getting payed off to keep it a secret. Im going to run my truck half off hydrogen half gas. I will be making the hydrogen under the hood by running electricity through water with stainless steel cells. the hydrogen will get ****** in through the intake and it is 2 times as powerful as gas. The truck will sense the change and adapt.

 
I couldnt do that to a lightning. I figured someone else who could afford it would drive it as it was meant to be.
400whp/495tq sure was fun though. 10mpg wasnt. $104 for 270-300 miles hurts the pocket as much as i drive to vegas to see the folks.
yup its expensive to drive this babies now indays:D filled mine up few days ago and it was around 95 bucks:(

 
yup its expensive to drive this babies now indays:D filled mine up few days ago and it was around 95 bucks:(
Probably another downer was moving from VA to CA. Had to retune for 91 octane, and lost about 20whp. On top of that, we were pretty active in a ford lightning club (about 40 trucks).

Out where i live there isnt too many.

Where you live SVT?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
7
1K
The tricky bit is that they're soft and floppy and they may be stretched a tad to go over the frames. I've used them in the past and come out...
6
2K
In order to answer your question, I would need to know what model (e.g. SW4200, SW7524DVC). Also, are you looking to make a ported box or sealed?
3
2K
Thanks everyone for the feedback. I got scared of the 4th being to much for a newbie but did end up building a box to 2.1 Cubic Foot tuned to...
7
2K
Love this sub, hate AB's site, short on info for sure. American Bass XR-10D2 box recomend: If you want to tune a 2.75 Cu Ft box (for two of these...
11
3K

About this thread

bjfish11

5,000+ posts
FisherCustoms.com
Thread starter
bjfish11
Joined
Location
Garden Plain, KS
Start date
Participants
Who Replied
Replies
31
Views
4,243
Last reply date
Last reply from
SVTLightning01
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0
1000007974.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top