CDT CL62/CL6ex and Amp

[Dollar12 10+ year member]

I was looking into getting a set for these (CDT CL62/CL6ex) for a 2012 Tundra Crewmax. I know that there's certain fit problems with 6 1/2s in tundras, but does anyone know if these will fit properly without adjustments?

Also the CL62 says that they are rated 190watts rms.Im assuming thats for both, so about 95 watts are needed per side? Same as the ClL6ex rated at 110 watts rms, so 55 per side?

I was looking at a few amps and was wondering if this would be too much power (rates for 4 ohms)

Alpine MRX-F65 110x4

JL XD 400/4 75x4

Alpine PDX F4 100x4

RF 600-4D 100x4

RF 400-4D 75x4

Also which amp would you prefer for these sets of speakers?

thanks

Click to read more...

 

[ace_800 5,000+ posts]

Not sure about fitment, but thats 190/speaker, so 380 total. You will need a pretty strong amp to run them, if you are looking at one of those amps I would say you need to bridge them to get the full potential of those CL62's.

 

[trumpet 5,000+ posts]

Any of those amps will do just fine on the speakers you mentioned. You don't need to match the amplifier and speaker RMS power ratings. Pick the amp that you like best.

 

[mylows10 5,000+ posts]

you can also get the cdt amp the sqa 4075 if you want it all to match.i'll be going to cdt in the morning to pick up some things,could grab these if you like and have them shipped out tomorrow