Nikolai Cvetkov
CarAudio.com Newbie
Hello all,
Can I put LTO Yinlong batteries as second bank in the trunk to power up 3k amplifier...
I had 90A alt and 80Ah batt ... But when bass hits I drop from 14v to 12.9... ive put 120Ah and had drop to 13.2v ... So few weeks ago I bought 180A alt so now my drop is to 13.3/4 ... I guess stock alternator cant handle well such power. I have only 1 battery under the good lead acid 100Ah ... People say i can put second 100Ah battery but lead acid/ agms are not so effective and I think i still will have voltage drop issues ... I connected volt meter to my amplifier and I read 14.2 on idle and 13.3-13.7v when bass hits. Before i had clip indicator on almost on every frequency 24hz-60hz .. while the clip now blink sometimes on frequency above 45hz ... Im not sure if its caused by the voltage drop because on freqs. Above 37/38 hz my voltage drop is not that much... Barely go under 13.9v.
So my question is can I put 35/40Ah LTO yinlong batteries and how many baterries I may need and how to connect them ?
Ive upgraded my wires in the car. From alt to main batt 25mm2 OFC (welding wire) ... And again 25mm2 from main batt to the amp in the trunk and 25mm2 ground. And second question . i measure 14.4v on main batt(or alt ) no matter where I measure ... But If i measure directly on the amp i measure 0.2v under the voltage I have. Could it be caused by bad ground .. cuz I use 80cm long ground wire under the back seats .. no heat or anything? I hear my turn signals from the woofer and when volume is at 0 and start rusing it to 24 i still hear like the volume button .. recently I was hearing my engine so changed the rca with stage 3 and fixed this but now I hear other accessories. I would be thankful if you guys help me little
Can I put LTO Yinlong batteries as second bank in the trunk to power up 3k amplifier...
I had 90A alt and 80Ah batt ... But when bass hits I drop from 14v to 12.9... ive put 120Ah and had drop to 13.2v ... So few weeks ago I bought 180A alt so now my drop is to 13.3/4 ... I guess stock alternator cant handle well such power. I have only 1 battery under the good lead acid 100Ah ... People say i can put second 100Ah battery but lead acid/ agms are not so effective and I think i still will have voltage drop issues ... I connected volt meter to my amplifier and I read 14.2 on idle and 13.3-13.7v when bass hits. Before i had clip indicator on almost on every frequency 24hz-60hz .. while the clip now blink sometimes on frequency above 45hz ... Im not sure if its caused by the voltage drop because on freqs. Above 37/38 hz my voltage drop is not that much... Barely go under 13.9v.
So my question is can I put 35/40Ah LTO yinlong batteries and how many baterries I may need and how to connect them ?
Ive upgraded my wires in the car. From alt to main batt 25mm2 OFC (welding wire) ... And again 25mm2 from main batt to the amp in the trunk and 25mm2 ground. And second question . i measure 14.4v on main batt(or alt ) no matter where I measure ... But If i measure directly on the amp i measure 0.2v under the voltage I have. Could it be caused by bad ground .. cuz I use 80cm long ground wire under the back seats .. no heat or anything? I hear my turn signals from the woofer and when volume is at 0 and start rusing it to 24 i still hear like the volume button .. recently I was hearing my engine so changed the rca with stage 3 and fixed this but now I hear other accessories. I would be thankful if you guys help me little