Mounting sub box

  • 4
    Participant count
  • Participant list
I would put two Eyelets on front and back close to the bottom of the enclosure with Toggles, rubber washers, and metal washer to seal the penetration to have a rigid hold down. Then run a ratchet strap through the seat to the front wrapped and secure the enclosure to the back seat. Shouldnt move unless you roll the vehicle over a couple times
 
Activity
No one is currently typing a reply...

Similar threads

Holefully he doesn’t hook batteries in series thinking it halves the voltage…..
29
2K
Ok, I will use the OEM location and wiring. The 5.25's are lower door. Buick gave it some thought because there is a plastic inner panel with a...
4
54
It is a wives tale if the only evidence could be coincidental. I agree that vibration is bad for everything except women, but that doesn't mean...
32
5K
just use riv-nuts or clip-nuts, made for blind fastening. some window weld should hold the ring on there pretty good..... being 4x6, you could...
4
1K

About this thread

Furgis

CarAudio.com Newbie
Thread starter
Furgis
Joined
Location
Earl Grey, Saskatchewan
Start date
Participants
Who Replied
Replies
3
Views
1,135
Last reply date
Last reply from
audiobaun
1715380631101.png

Doxquzme

    May 10, 2024
  • 0
  • 0
20240510_180834.jpg

3toneEYZ

    May 10, 2024
  • 0
  • 0

New threads

Top