On/off switch for rearview camera

  • 2
    Participant count
  • Participant list
the best advice I can gicve is to run it through a relay where either source would close the coil to energize the cam. since it would be using 2 seperate 12v sources 1) the rear tail light, 2) the switch you control. the other thing I can think of is 3 way switching as in a house where you can turn on and off from 2 or more locations.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Like @maylar said, delay the turn on to the amplifier only. 3 to 5 seconds should take care of it.
8
400
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
371
Any indication that a loose wire may be the issue? I'd start by checking all the +/- connections to see if one has come lose or is starting to...
1
657
Disconnect the RCA's or hi-level input to the JBl amp. turn the system on, If the noise continues, it's a ground or noise issue with the amp.If it...
1
586

About this thread

GreenSmoke

Junior Member
Thread starter
GreenSmoke
Joined
Location
Dallas, Texas
Start date
Participants
Who Replied
Replies
1
Views
497
Last reply date
Last reply from
tommydh
Buick Amp Connector.JPG

maylar

    Jun 2, 2024
  • 0
  • 0
1717274743729.png

Doxquzme

    Jun 1, 2024
  • 0
  • 0

New threads

Top