Please help!

  • 3
    Participant count
  • Participant list

carsonevans

Junior Member
This problem is kind of long but please bare with me. A few months ago I was replacing my trunk light and it sparked when I disconnected it. Long story short, my trunk light and all accessories in the car are on one fuse and when I replaced it a while back, everything was fine. However, earlier today I replaced another light in my trunk and nothing sparked or anything, but now, nothing in my car has power except ignition, lighting, and air conditioning. I replaced the fuse thinking it was that, but still nothing. Please get back to me as soon as you can. I have a 2004 Hyundai Sonata.

 
Might need a new ignition switch. the ignition controls most of the accessories. i had to replace mine once and had it done by a local shop, it wasnt to expensive. maybe like 100 bucks. if the fuses are all fine, make sure you check all of them, not just the one you replaced. check the interior fuses, and in the engine compartment fuses, but i would double check everything. good luck !

 
Have you checked the fuses under the hood, these are generally your main power distribution fuses and more often than not they are over looked in the process of trying to find a blown fuse. I would also recomend if you are not already doing this to use a DMM to test for blown fuses by measuring the voltage on each side not by a continuity test. I have seen fuses before that look fine and pass continuity but will not conduct higher amperage.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
7
1K
Is this a blue or blue/white wire from the Kenwood? The ACC wire is red and although that should turn on the amp, it is not the prefered wiring...
1
763
The sound deadening is going to be more about preventing vibration from metal surfaces and adding unwanted noise. Does it have the JBL system...
1
747
It's called the K.I.S.S. preciniple ("Keep it simple, stupid!")... Takes the guesswork out of parallel/series wiring.
2
964
As for which signal to use, I tried all combinations and getting signal from the dash and front & rear doors is the only way the system sounded...
15
2K

About this thread

carsonevans

Junior Member
Thread starter
carsonevans
Joined
Location
Tampa, FL
Start date
Participants
Who Replied
Replies
3
Views
955
Last reply date
Last reply from
carsonevans
20240519_201344.jpg

audiobaun

    May 19, 2024
  • 0
  • 0
Screenshot_20240519-213549.png

1aespinoza

    May 19, 2024
  • 0
  • 0

New threads

Top