Recent content by x2o

You can try fiberglassing on top of it, may help with it's rigidity. I had a box once that had a port wall about 34" wide (long narrow slot port), and fiberglass helped significantly but proper bracing would be best of course.

Seriously..?

Did the BTL really get suggested in an "SQ" thread?

He could be running 6 low powered 12's...

Which RE tweeters? the XXX ones?

Not to mention the DMX's are pretty nice motors too.

By the way, it's a common mistake on that audiopipe for people to think they are 1ohm stable. Many websites say it is 1 ohm stable and one year the audiopipe product catalog (I think in 2009) was misprinted and stated it as well.

Pictures help us know that you actually have the product, hence why it's preferred to take a picture with a correctly set timestamp and your ca username. And if that's the AudioPipe AP30001D, it isn't one ohm stable. It is 2 of the 1500.1 boards internally strapped, so it's rated at 2ohms. Some...

There's a thread about it on DIYMA from '09 or so and it seems to be a nice amp. Says that only 2 were sent to each dealer and usually used as display models. I wasn't able to find much info on them though... Yep, they seem to have been made by PPI.

I know someone down here in south FL that has a walled PT too. I believe the current setup is (10) or (12) 12"s in the wall, but don't really remember..

Maybe. I've seen people with good electrical systems run them below 2 ohms daily.

lol, when you google 'gorilla shield' the only relevant thing that comes up is this thread..

What kind of car is that? If it's a Dodge Ram....

Well, part of it might be cosmetic, but mounting the subs inverted will also help save on displacement, in a multiple sub setup this might help you achieve a smaller box. Mounting it standard with the motor in the box causes a bit of displacement, on some SPL motors it is around .2 cubic feet of...

I know they can still take power, was just asking because I already have 3 of the motors with cooling vents in the gap on the backplate and might have been interested in this one. It's a great motor nonetheless, just two slightly different designs. I believe the main reason of the backplate...